Kenwood NXR-1700 Function Reference page 194

14 IP INTERFACE FUNCTION / 14.1 Console
Use of the repeater is permitted if the repeater receives the Registration request from a Console and the UID of the
Console matches the configured UID. By permitting use of the repeater, the transmission and reception of audio and
data are enabled in the Console. Data communication supports Status, Short Data, and Long Data. In addition, only
audio is supported for Analog communication.
If Group Registration of a Console is received and the GID matches the GID configured in User List, the use of the
repeater is permitted for the Console to receive a Group Call.
If an Analog carrier is received in DMR Mode or Analog Mode, audio with an Analog GID as the destination is output to
an IP on Slot 1. Refer to Analog GID
For transmission of audio with an Analog GID as the destination from a Console in DMR Mode or Analog Mode, the
behavior of the repeater does not change even if Slot 1 or Slot 2 is selected.
If an Analog carrier is received in NXDN Mode, audio with an Analog GID as the destination is output to an IP by
Channel Spacing (NXDN) configured for the channel. Refer to
The audio codec of the repeater and Console supports AMBE+2 and G.711 (PCMU).
Note
 If an inactive SIP connection occurs, such as if audio data is interrupted, after SIP connection is made, the SIP connection for
the repeater ends when a certain length of time (65 sec) elapses.
Busy Monitoring
This function allows the Busy Monitoring information of the repeater to be sent to a Console. If a Busy Monitoring
notification request is received from a Console, the repeater notifies to the Console of the Busy Monitoring information.
Configuration
Product Information
Repeat Disable
If the repeater receives a Busy Monitoring notification request from a Console, the repeater notifies to the Console of
the Busy Monitoring information of the repeater.
If operated in Analog Mode, the Cross Busy status in Analog can be acquired by Busy Monitoring notification.
If operated in DMR Mode, the Slot 1 status, Slot 2 status, and Cross Busy status in Analog can be acquired by Busy
Monitoring notification.
If operated in NXDN Mode, the RX Status of the repeater can be acquired by Busy Monitoring notification.
Note
The repeater supports Busy Monitoring using AIS if operated in Analog Mode or DMR Mode.
・
The repeater supports Busy Monitoring using NX-NNPP if operated in NXDN Mode.
・
FUNC (E)/ Ver 2.00
for details.
Table 14-2 Busy Monitoring
Description
If IP Interface is enabled in Busy Monitoring, a response can be returned for a
Busy Monitoring notification request from a Console.
If Repeat Disable is configured in AUX Input, the Busy status is acquired.
193
Analog GID for details.