7 DMR DIGITAL COMMUNICATIONS / 7.8 Limiting the IDs for Repeat Transmission (User List (GID)/ User List
(UID))
Configuring the GIDs Permitted for Repeat Transmission (GID List)
GID List is the list in which the GIDs permitted for repeat transmission on a digital channel are configured.
The repeater repeats when receiving a call by the GID which is configured in GID List and for which "On" is configured
in Valid. Because subscriber units using unauthorized GIDs are not repeated, the repeater cannot communicate with
these subscriber units. In this case, the receiving subscriber unit is in a silent receiving mode because the repeater
continues to transmit an idle signal to allow the call to be transmitted in a vacant slot.
A maximum of 1000 GIDs can be configured in GID List by using KPG-D7 or Web Tool.
Note
・
If "Unaddress" is configured in GID of GID List, the repeater is permitted to use the codes $FFFFE0 to $FFFFEF.
If "ALL" is configured in GID of GID List, the repeater is permitted to use the codes $FFFFF0 to $FFFFFF.
・
Configuration using KPG-D7
Configuring GID List ( Edit > User List > GID List)
・
Configuration using Web Tool
・
Configuring GID List ( Edit > User List > GID List > GID List)
FUNC (E)/ Ver 2.00
Figure 7-1 GID List
118