Kenwood NXR-1700 Function Reference page 207

17 MODE / 17.2 Overwriting Firmware (Firmware Programming Mode)
When the system is reset due to power outage while updating firmware
When the repeater turns off due to a power failure, etc., the performance of the appropriate measure in each case is
recommended.
Table 17-1 Appropriate Measures When the Repeater Turns Off Due to a Power Failure, Etc.
State When a Condition
Power Failure,
Etc. Occurs
After firmware If firmware update has not
update completes restarted after the repeater
recovers from a power failure, etc.
During Reboot If the "Reboot" command by the
Web Tool is used
If "RESET" by the D-sub 25-pin
connector behaves
During Shut Down If "Power Off" of the OLED display
is used
FUNC (E)/ Ver 2.00
Appropriate Measure
Perform firmware update again.
Perform firmware update again.
Same as above.
If the repeater automatically restarts,
perform firmware update again.
Execute "Power Off" by the OLED display
after firmware update.
206
Remarks
-
-
-
-