Kenwood NXR-1700 Function Reference page 35

1 FUNCTIONS AND PANEL LAYOUT / 1.3 OLED display
Menu List
The following OLED display menus are available if the repeater starts in the user mode:
Layer Item
Channel Number
Channel Name
RX Frequency
Channel
TX Frequency
Information
Operation Mode
Repeater Model Name
Information
Market Code
Serial Number
NXDN ESN
Firmware Version
License
Hot Standby Mode
Host IP Address
Subnet Mask
Default Gateway
MAC Address
Hot Standby Status
Network
Virtual IP Address
Information
Beacon Operating
Status
NTP Synchronized
Status
Control Test PTT Control
FUNC (E)/ Ver 2.00
Table 1-8 Menu List
Description
Displaying the channel number
Displaying the channel name
Displaying the RX frequency MHz
Displaying the TX frequency MHz
If the TX frequency is not configured,
"TX No Freq" is displayed.
Displaying Operation Mode
Model name
Market code
Serial number of the main unit
Displaying NXDN ESN
Firmware version
Type of the assigned license
Hot Standby: Main/Sub
Displaying the IP address of the main
unit
Displaying the subnet mask
Displaying the Default Gateway address
Displaying the MAC address
HSB Active/ HSB Standby/ HSB Failsoft
If the Valid of Hot Standby is "OFF"
The line is not displayed.
Displaying the VIP
If the Valid of Hot Standby is "OFF"
The line is not displayed.
Beacon Master/ Member/ Local/ None
If Beacon is disabled, the line is not
displayed.
Synchronized: OK
Synchronized: NG
The line is not displayed if Valid is disabled
for an NTP Client.
PTT control for a voice call used for
testing
34
Remarks
Read Only
Read Only
Read Only
Read Only
Read Only
Read Only
Read Only
Read Only
Read Only
Read Only
Read Only
Read Only
Read Only
Read Only
Read Only
Read Only
Read Only
Read Only
Read Only
Read Only
Upper row: Off
Lower row: On