Kenwood NXR-1700 Function Reference page 115

7 DMR DIGITAL COMMUNICATIONS / 7.5 Continuing Transmission for a Certain Length of Time After Various
Transmissions End
Data Hangtime
Data Hangtime is the function that is used to retain a channel for a certain length of time after the repeater ends
transmission of a data communication signal.
The repeater starts repeat transmission after a subscriber unit transmits a data communication signal. The repeater
retains a channel and continues repeat transmission for the length of time configured in Data Hangtime after the
repeater ends transmission of a data communication signal.
Note
・ This function works on a channel with "DMR" or "Mixed" configured in Channel Type.(Refer to
Method of a Channel (Channel
While the Data Hangtime is counting down, the repeater does not start repeat transmission even if the repeater receives an
・
analog signal on a channel with "Mixed" configured in Channel Type.
・ If the subscriber unit disables A-bit (Response Expected) and transmits a data communication signal, Data Hangtime
becomes disabled.
If "TA Direct" is configured in Operation Mode, Data Hangtime is not activated.
・
・ This function works during transmission by Repeat PTT/ Network PTT/ Console PTT.
Configuration using KPG-D7
Configuring Data Hangtime ( Edit > Optional Features > Common Page 1 > Repeater/ External/ Network/
・
Console PTT > Data Hangtime)
Channel Hangtime (Mixed Channel)
Channel Hangtime (Mixed Channel) is the function that is used to retain a channel for a certain length of time after
the repeater ends transmission in the DMR format on a mixed channel.
The repeater starts repeat transmission after a subscriber unit transmits a DMR digital signal on a mixed channel.
The repeater retains a channel and continues repeat transmission for the length of time configured in Channel
Hangtime (Mixed Channel) after the repeater ends transmission of a DMR digital signal.
Configuration
Channel Hangtime (Mixed
Channel)
Call Hangtime Enable/Disable
FUNC (E)/ Ver 2.00
Type).)
Table 7-6 Configuration of Channel Hangtime (Mixed Channel)
Description
The length of time for which a channel is retained after the repeater ends
transmission of an audio signal is configured.
Channel Hangtime (Mixed Channel) can be toggled between enabled and
disabled by using Channel Hangtime Enable/Disable in the Remote Control
function of the Web Tool.
114
Configuring the Reception