Ran Encode/ Decode - Kenwood NXR-1700 Function Reference

8 NXDN DIGITAL COMMUNICATIONS / 8.2 RAN Encode/ Decode

RAN Encode/ Decode

8.2
Same as QT/ DQT, RAN (Radio Access Number) is also the function to mask unnecessary reception. RAN can be
used for transmission and reception in the NXDN format.
If transmission is performed on a channel with NXDN configured in Channel Type or a channel with NXDN configured
in Transmit Mode, the RAN configured in RAN Encode is sent.
If the RAN matching the RAN configured in RAN Decode is received on a channel where NXDN or Mixed is configured
in Channel Type, the mute is reset and the received audio is output from the RA of D-Sub 25 pin. If a headset is
connected to the repeater, the received audio is output from the headset as well. Also, the repeat behavior occurs on
the channel where "Repeat" is configured in Operation Mode.
Configuration
RAN Decode
RAN Encode
Note
 If "None" is configured in RAN Decode, the mute is reset for all RAN receptions and the RX2 LED lights green.
If "Repeat" is configured in Operation Mode, the repeat behavior occurs.

 When the repeater is receiving in the Monitor ON state, the mute is reset for all RANs even if anything other than
"None" is configured in RAN Decode, but the repeat behavior does not occur if RAN is inconsistent.
Configuration using KPG-D7
・ Configuring RAN Decode ( Edit > Channel Information > Channel Edit > RAN Decode)
・
Configuring RAN Encode ( Edit > Channel Information > Channel Edit > RAN Encode)
FUNC (E)/ Ver 2.00
Table 8-3 RAN Encode/Decode
Description
The RAN to be waited for when an NXDN signal is received is configured for each
channel.
The RAN to be used when an NXDN signal is transmitted is configured for each channel.
128