Kenwood NXR-1700 Function Reference page 124

7 DMR DIGITAL COMMUNICATIONS / 7.8 Limiting the IDs for Repeat Transmission (User List (GID)/ User List
(UID))
Note
・
If the UID and GID to be used for a digital signal call are not permitted for use, the call cannot be made because the repeater
does not transmit the repeat transmission. In this case, the receiving subscriber unit is in a silent receiving mode because the
repeater continues to transmit an idle signal to allow the call to be transmitted in a vacant slot.
Configuration using KPG-D7
Configuring User List (GID) ( Edit > Channel Information > Channel Edit > User List (GID))
・
Configuring User List (UID) ( Edit > Channel Information > Channel Edit > User List (UID))
・
Configuring the Conditions to Initiate an Intersite Call (Site Group)
Site Group is the function to determine how the repeater initiates an Intersite Call when a Group Call to the target GID
is initiated or when an Individual Call to the target UID is initiated.
By using KPG-D7, the behavior of the repeater when the repeater initiates an Intersite Call can be configured for each
ID configured in UID List and UID Range List as well as GID List and GID Range List.
If an Individual Call is received, an Intersite Call will be sent according to the Site Group configured for the target Unit
ID. However, if both UID List and UID Range List are disabled, an Intersite Call will be sent according to the Site List
configured for each channel.
If a Group Call is received, an Intersite Call will be sent according to the Site Group configured for the target Group
ID. However, if both Group ID List and Group ID Range are disabled, an Intersite Call will be sent according to the
Site List configured for each channel.
Depending on the configuration in Site Group, the repeater behavior when initiating an Intersite Call varies as follows:
FUNC (E)/ Ver 2.00
Figure 7-5 User List (GID)/ User List (UID)
123