Kenwood NXR-1700 Function Reference page 32

1 FUNCTIONS AND PANEL LAYOUT / 1.3 OLED display
The operations when editing Network Information are explained.
Example of the Host IP Address edit
screen
FUNC (E)/ Ver 2.00
When the Knob is pressed after Edit is selected in Network
Information, the selection menu shown to the left is displayed.
1. By pressing the Knob while Host IP Address is selected,
migration to the Host IP Address edit screen occurs.
2. By pressing the Knob while Subnet Mask is selected, migration
to the Subnet Mask edit screen occurs.
3. By pressing the Knob while Default Gateway is selected,
migration to the Default Gateway edit screen occurs.
4. By pressing the Knob while Save is selected, the combination of
the edited Host IP Address, Subnet Mask, and Default Gateway
configurations is checked, the error is displayed when there is a
problem, and the configurations are saved and reflected if there
are no problems.
5. By pressing the Knob while Cancel is selected, edits are
discarded and the Network Information display is restored.
Host IP Address edit screen/ Default Gateway edit screen
Host IP Address and Default Gateway are configured in the range
from 1.0.0.0 to 223.255.255.255.
However, the following addresses cannot be configured:
・
127.***.***.***
・
128.000.***.***
・
191.255.***.***
・
192.000.001.***
・
223.255.255.***
Configuration is done in order from the 1st octet for Host IP
Address and Default Gateway.
・
The value of the selected octet is changed by rotating the
Knob.
・
Selection migrates to the next octet by pressing the Knob.
・
If an unavailable address is selected, it is skipped or adjusted.
・
By holding the Knob while the 2nd octet or later is selected, the
1st octet can be restored again.
31