Loosen Screws In Safety Covers; Removing The Covers; Tilting And Re-Erecting The Machine Head - Dürkopp Adler 650-10 Service Instructions Manual

3. Cut off any overlapping cable ties.

3.2 Loosen screws in safety covers

Screws used in safety covers must not be completely removed from the
screw hole.
1. As soon as the screws are loosened, remove the cover.
 The screws can either remain in the housing or in the cover.
Such screws are identified in the text by the suffix
safety cover.

3.3 Removing the covers

For many types of setting work, you will have to remove the machine
covers in order to access the components.
Described here is how to remove the individual covers and how to refit
them. Just the covers that need to be removed is then specified in the text
for that particular type of setting work.

3.3.1 Tilting and re-erecting the machine head

To access the components on the underside of the machine, swivel up the
machine head.
Fig. 1: Tilting and re-erecting the machine head
(1) - Machine head
(2) - Tray
Tilting the machine head
To tilt the machine head:
1. Tilt the machine head (1) as far as it will go.
2. Loosen all five screws (3).
14
Important
The cables must be fixed in place!
(3) - Screws
Service Instructions 650-10 - 01.0 - 08/2016
Individual settings