Setting The Feed Dog Movement; Setting The Feed Dog Feed Movement - Dürkopp Adler 867-M PREMIUM Service Instructions Manual

11. Tighten the connection to the tie rod using the screws (1).
 In the process, make sure that the feed dog height has the correct
12. Finish the service routine.

8.3 Setting the feed dog movement

The feed dog moves in an elliptical cycle. To align this correctly, the feed
movement, the stroke height, and the stroke movement of the feed dog all
have to be set.
Order
First, check the following setting:
8.3.1
Proper setting
At a handwheel position of 190°, the feed dog should stop when the man-
ual bartack button (1) is pressed down at maximum stitch length.
To set the feed dog feed movement:
1. Execute the service routine Feed Dog > Feed Dog Move ( p. 14).
 The software is used to define the necessary presettings on the
Fig. 26: Setting the feed dog feed movement (1)
(1) - Manual bartack button
2. Check if the sewing drive is at 190°.
3. If needed, use the handwheel to correct the position manually.
38
setting ( p. 39).
• Feed dog position ( p. 35)

Setting the feed dog feed movement

machine.
Setting the feed dog
Service Instructions 867-M PREMIUM - 03.0 - 05/2017
①
ü