Features; Figure 50: Wbm Page "Features; Table 42: Wbm Page "Features - WAGO -I/O-SYSTEM 750 XTR Manual

126 Configuring via the Web-Based Management System (WBM)WAGO-I/O-SYSTEM 750 XTR
Pos : 69.58 /Serie 750 ( WAGO-I/O-SYST EM)/Web-Bas ed-M anagement-Sys tem WBM/Seite F eatur es/F eatur es - Einl eitung @ 4\mod_1242635282062_21.doc x @ 33442 @ 2 @ 1
9.9

Features

Use the "Features" WBM page to enable or disable additional functions.
Pos : 69.59 /Serie 750 ( WAGO-I/O-SYST EM)/Web-Bas ed-M anagement-Sys tem WBM/Seite F eatur es/F eatur es - Bild (750- 829, 831, 880, 881, 882, 885, 852, 352) @ 8\mod_1276864252513_21.doc x @ 58171 @ @ 1

Figure 50: WBM Page "Features"

Pos : 69.60 /Serie 750 ( WAGO-I/O-SYST EM)/Web-Bas ed-M anagement-Sys tem WBM/Seite F eatur es/F eatur es - T abell e (750-829, -831, - 88x, - 852) @ 6\mod_1265211909421_21.doc x @ 49258 @ @ 1

Table 42: WBM Page "Features"

Additional Functions
Entry
Autoreset on
system error
BootP Request
before Static-IP
Non-adaptive Kbus
speed active
Pos : 69.61 /D okumentati on allgemei n/Gli ederungsel emente/---Seitenwec hs el--- @ 3\mod_1221108045078_0.doc x @ 21810 @ @ 1
Manual
Version 1.3.0
750-352/040-000 FC ETHERNET G3 XTR
Default Description
Enables an automatic software reset to be conducted

when a system error occurs

Disables an automatic software reset to be conducted

when a system error occurs
Automatically set the static IP address enabled.
For this configuration, the fieldbus coupler/

controller uses a statically configured IP address if the
request via BootP fails.

Automatically set the static IP address disabled.
 For this configuration, the IP address request via BootP
is repeated in the event of error.
Disable the rate adjustment of the local bus for short
fieldbus nodes. With short fieldbus nodes, doing so

makes more computing power available for the PLC

application. The local bus rate is correspondingly
lower.
Enables the rate adjustment of the local bus.
