Tektronix KEITHLEY SourceMeter 2606B Reference Manual page 751

Section 15: TSP command reference
tsplink.master
This attribute reads the node number assigned to the master node.
Type TSP-Link accessible
Attribute (R) Yes
Usage
masterNodeNumber = tsplink.master
masterNodeNumber
Details
After doing a TSP-Link reset (tsplink.reset()), use this attribute to access the node number of
the master in a set of instruments connected over TSP-Link.
Example
LinkMaster = tsplink.master
Store the TSP-Link master node number in a variable called LinkMaster.
Also see
tsplink.reset()
tsplink.node
This attribute defines the node number.
Type TSP-Link accessible
Attribute (RW) Yes
Usage
nodeNumber = tsplink.node
tsplink.node = nodeNumber
nodeNumber
Details
This command sets the TSP-Link node number and saves the value in nonvolatile memory.
Changes to the node number do not take effect until tsplink.reset() from an earlier TSP-Link
instrument is executed on any node in the system.
Each node connected to the TSP-Link system must be assigned a different node number.
Example
tsplink.node = 3
Sets the TSP-Link node for this instrument to number 3.
Also see
tsplink.reset()
tsplink.state (on page 15-381)
15-378
Affected by
Not applicable
The node number of the master node
(on page 15-380)
Affected by
Not applicable
The node number of the instrument or enclosure (1 to 64 )
(on page 15-380)
Model 2606B System SourceMeter® Instrument Reference Manual
Where saved
Not applicable
Where saved
Nonvolatile memory
2606B-901-01 Rev. C November 2021
Default value
Not applicable
Default value
1