Tektronix KEITHLEY SourceMeter 2606B Reference Manual page 380

Model 2606B System SourceMeter® Instrument Reference Manual
TSP commands
The TSP commands available for the instrument are listed in alphabetical order.
beeper.beep()
This function generates an audible tone.
Type TSP-Link accessible
Function Yes
Usage
beeper.beep(duration, frequency)
duration
frequency
Details
You can use the beeper of the 2606B to provide an audible signal at a specified frequency and time
duration. For example, you can use the beeper to signal the end of a lengthy sweep.
The beeper does not sound if it is disabled. It can be disabled or enabled with the beeper enable
command, or through the virtual front panel.
Example
beeper.enable = beeper.ON
beeper.beep(2, 2400)
Enables the beeper and generates a two-second, 2400 Hz tone.
Also see
beeper.enable
2606B-901-01 Rev. C November 2021
Affected by
The amount of time to play the tone (0.001 s to 100 s)
The frequency of the tone in Hertz (Hz)
(on page 15-8)
Section 15: TSP command reference
Where saved Default value
15-7