Tektronix KEITHLEY SourceMeter 2606B Reference Manual page 593

Section 15: TSP command reference
Also see
Filters (on page 5-49)
reset() (on page 15-176)
setup.recall()
smuX.measure.filter.count
smuX.measure.filter.enable
smuX.reset() (on page 15-231)
smuX.measure.highcrangedelayfactor
This attribute contains a delay multiplier that is only used during range changes when the high-capacitance mode
is active.
Type TSP-Link accessible
Attribute (RW) Yes
Usage
delayFactor = smuX.measure.highcrangedelayfactor
smuX.measure.highcrangedelayfactor = delayFactor
delayFactor
X
Details
This delay multiplier is only active when the high-capacitance mode is active.
Example
smua.measure.highcrangedelayfactor = 5
Also see
High-capacitance mode
reset() (on page 15-176)
setup.recall()
smuX.reset() (on page 15-231)
smuX.source.highc
15-220
(on page 15-191)
(on page 15-217)
(on page 15-218)
Affected by
Instrument reset
SMU reset
Recall setup
The delay factor; set to a value between 1 and 99
SMU channel (for example, smua.measure.highcrangedelayfactor applies to
SMU Channel A)
(on page 5-52)
(on page 15-191)
(on page 15-237)
Model 2606B System SourceMeter® Instrument Reference Manual
Where saved
Saved setup
Increases the delay used during range changes for
SMU channel A by a factor of 5.
2606B-901-01 Rev. C November 2021
Default value
10