Tektronix KEITHLEY SourceMeter 2606B Reference Manual page 291

Section 13: Introduction to TSP operation
io.input() (on page 15-118)
io.open() (on page 15-119)
io.output() (on page 15-119)
io.read() (on page 15-121)
io.type() (on page 15-122)
io.write() (on page 15-123)
os.remove() (on page 15-167)
os.rename() (on page 15-167)
The following standard I/O commands are not supported:
File
▪
fileVar:lines()
▪
fileVar:setvbuf()
Instrument identification
These commands store strings that describe the instrument.
localnode.description
localnode.model
localnode.revision
localnode.serialno
LAN and LXI
The LAN commands have options that allow you to review and configure network settings. The
lan.config.* commands allow you to configure LAN settings over the remote interface.
You must send lan.applysettings() for the configuration settings to take effect.
The lan.status.* commands help you determine the status of the LAN.
The lan.trigger[N].* commands allow you to set up and assert trigger events that are sent over
the LAN.
Other LAN commands allow you to reset the LAN, restore defaults, check LXI domain information,
and enable or disable the Nagle algorithm.
lan.applysettings()
lan.autoconnect
lan.config.dns.address[N]
lan.config.dns.domain
lan.config.dns.dynamic
lan.config.dns.hostname
lan.config.dns.verify
lan.config.duplex
lan.config.gateway
lan.config.ipaddress
13-8
I/O
▪
io.lines()
▪
io.popen()
(on page 15-154)
(on page 15-155)
(on page 15-160)
(on page 15-161)
(on page 15-125)
(on page 15-125)
(on page 15-126)
(on page 15-127)
(on page 15-127)
(on page 15-128)
(on page 15-129)
(on page 15-129)
(on page 15-130)
(on page 15-131)
Model 2606B System SourceMeter® Instrument Reference Manual
2606B-901-01 Rev. C November 2021