Tektronix KEITHLEY SourceMeter 2606B Reference Manual page 782

In this section:
Common command summary ................................................ 16-1
Script command equivalents .................................................. 16-2
Command reference .............................................................. 16-3
Common command summary
The IEEE Std 488.2 common commands that are supported by the 2606B are summarized in the
following table. Although commands are shown in uppercase, common commands are not case
sensitive, so you can use either uppercase or lowercase. Although these commands are essentially
the same as those defined by the IEEE Std 488.2 standard, the 2606B does not strictly conform to
that standard.
Unlike other commands, like those listed in
command must be sent in a separate message.
The common commands cannot be used in scripts.
Command
*CLS
*ESE mask
*ESE?
*ESR?
*IDN?
Name
Clear status
Event enable command
Event enable query
Event status register query
Identification query
Common commands
TSP commands (on page 15-7), each common
Description
Clears all event registers and Error Queue. For detailed
information including status commands, see the
(on page 10-1).
Program the Standard Event Status Enable Register. For
detailed information including status commands, see the
Status model (on page 10-1).
Read the Standard Event Status Enable Register. For
detailed information including status commands, see the
Status model (on page 10-1).
Read/clear the Standard Event Enable Register. For detailed
information including status commands, see the
(on page 10-1).
Returns the manufacturer, model number, serial number, and
firmware revision levels of the unit. For detailed information,
see Identification query: *IDN?
Section 16
Status model
Status model
(on page 16-3).