Tektronix KEITHLEY SourceMeter 2606B Reference Manual page 815

In this section:
How do I find the serial number? ............................................ 18-1
How do I optimize performance? ............................................ 18-2
How do I upgrade the firmware? ............................................ 18-2
How do I use the digital I/O port? ........................................... 18-3
How do I trigger other instruments? ....................................... 18-3
How do I store measurements in nonvolatile memory? .......... 18-4
When should I change the output-off state? ........................... 18-5
How do I make contact check measurements? ...................... 18-5
How can I change the line frequency or voltage? ................... 18-5
Where can I get the LabVIEW driver? .................................... 18-6
Why is the reading value 9.91e37? ........................................ 18-6
How do I find the serial number?
Each 2606B has three serial numbers, one for the instrument and one for each module.
The instrument serial number is on a label on the front panel. This serial number is not available
through a remote interface.
The serial numbers for the modules are on labels on the rear panel. The serial number for a specific
module can be accessed through the virtual front panel or by using the
15-161) command over a remote interface.
To access the serial number from the virtual front panel:
1. If the 2606B is in remote operation, press the EXIT (LOCAL) key once to place the instrument in
local operation.
2. Select the MENU key.
3. Use the navigation wheel to scroll to the SYSTEM-INFO menu item.
4. Press the ENTER key. The SYSTEM INFORMATION menu is displayed.
5. Scroll to the SERIAL# menu item.
6. Press the ENTER key. The serial number for the module is displayed.
Frequently asked questions
Section 18
localnode.serialno (on page