Turning The Power On/Off - Roland VM-C7100 Owner's Manual

Chapter 1 Introduction

Turning the power on/off

Turn each device on in the following sequence. After all devices are turned on, adjust
the volume of each.
Precautions on turning the power on
• Once the connections have been completed (21), turn on power to your
various devices in the order specified. By turning on devices in the wrong
order, you risk causing malfunction and/or damage to speakers and other
devices.
• This unit is equipped with a protection circuit. A brief interval (a few
seconds) after power up is required before the unit will operate normally.
• Turn the power on after lowering the volumes of the console and the
connected audio equipment. If the volumes are raised, the audio equipment
may malfunction due to current overload the instant the power is turned on.
• Even with the volume lowered, a slight amount of sound may be heard
when the power is turned on. This should not be a cause for concern.
1. Digital multitrack tape recorder
2. Processor
The CTRL indicator blinks during startup. After the startup process is completed,
the indicator comes on.
3. Console
After the confirmation message appears, press [F2] (START) to begin the startup
process.
4. Digital-connected equipment (e.g., DAT, MD recorder or hard disk
recorder)
5. Analog-connected equipment (e.g., musical instruments, sound modules,
effects, microphone, CD player, MD player or tape recorder)
6. Audio equipment such as amplifiers and speakers
Turning the power off
Turn each equipment off in the opposite sequence in which it was turned on.
Points to check before turning the power off
• Make sure that Automix has been stored in the memory card.
Although Automix is stored in the console memory, it is, however, lost
after the power is turned off.
• The volumes of the console and the connected audio equipment are at
the lowest level.
If the volumes are raised, the audio equipment may malfunction due to
current overload the instant the power is turned off.
24
Turn the console on after
making sure that the CTRL
indicator has come on.
In order to turn the power
of the entire system on,
press [F4] (ON)
(highlighted) to
automatically start the
console startup process in
60 seconds.