Recording To Modify (Relative Rec) - Roland VM-C7100 Owner's Manual

Recording to modify (RELATIVE REC)

To add changes such as increasing/reducing the level to a set of auto-mixings
already recorded, perform relative recording (RELATIVE REC).
1. Press any of the buttons in SECTION to select one of the sections.
2. Press [AUTO-MIX] to set it to RELATIVE RECORDING (orange indicator).
3. Press [AUTO-MIX] under CH STATUS.
The status button for the channel is switched to the mode for auto-mixing.
4. Press the status button for the channel for which auto-mixing is to be
recorded to set it to the recording state (red indicator).
The Fader for the channel for which the auto-mixing is to be recorded automatically
moves to the center. The Fader functions as an operating device to determine how
much the values should be increased or decreased relative to the recorded data.
Placing the Fader above the center causes the values to be increased relative to the
recorded data while placing it below the center causes the values to be reduced
relative to the recorded data.
5. To record auto-mixing on another channel while playing it back, press the
status button for that channel to set it to the playback state (indicator
green).
6. Press any of the buttons in "PARAMETER VIEW on Fader" to select the
type of settings to be recorded.
7. Press [PLAY] to start recording auto-mixing.
The channel of the status button with the green indicator starts playback.
8. Operate the faders or knobs to record the data.
9. Press [STOP] to finish recording.
Chapter 11 Recording/Playing Back Fader or Knob Actions (Automix)
Relative recording can only
be performed on the
parameters subject to
operation with the Fader.
Changing the status of the
channel or auto-mixing, the
Fader returns to the
position it was in before
entering the RELATIVE
REC state.
Do not move the Fader
before starting recording of
auto-mixing. If you do so,
the current Fader position
will be interpreted as the
center when recording
starts, leading to failure to
revise the values to the
desired.
Press [UNDO/REDO] to
cancel auto-mixing just
recorded (UNDO). Pressing
[UNDO/REDO] once more
restores the auto-mixing
just recorded (REDO).
205