Reducing Signal Distortion (Attenuator) - Roland VM-C7100 Owner's Manual

3. Use the master fader to set the cue bus master level.
fig.06-02
4. Call up the cue bus master stereo balance by pressing [CH PAN] (CUE
PAN) in the PARAM VIEW on Fader area while holding down [SHIFT].
The CH PAN button turns green.
5. Use the master fader to set the cue bus master stereo balance.

Reducing signal distortion (attenuator)

Press the master fader's [CH EDIT] to set the master attenuators. These attenuators
help control the combined level of all of the signals coming into the main mix and
cue bus.
fig.06-03
Setting the MAIN OUT attenuator
1. Press [INPUT] or [MULTI IN] in the SECTION area.
2. Press the master fader's [CH EDIT] and CURSOR [UP], in that order.
3. Turn [V1] (MAIN BUS ATT LEVEL) to set the MAIN OUT attenuator.
Setting the cue bus attenuator
1. Press [INPUT] or [MULTI IN] in the SECTION area.
2. Press the master fader's [CH EDIT] and CURSOR [UP], in that order.
3. Turn [V3] (CUE BUS ATT LEVEL) to set the cue bus attenuator.
Chapter 6 Mixing Procedure 2 (Output and Monitor)
The master fader controls
the cue bus's stereo balance
when [CH PAN] (CUE
PAN) is pressed. As a
result, it cannot be used for
setting levels while in this
operating mode.
85