Restoring The Original Factory Settings (Factory Reset); Factory Reset Procedure - Roland VM-C7100 Owner's Manual

2
... Type 1/2 and copy protect switches
"MODE" specifies whether the digital audio signal to be output is and AES/EBU
broadcasting studio (TYPE 1), or a consumer-use digital audio device (TYPE 2). Place
the cursor, select with the V3 knob and enter with [F3] (SET).
Turning the "COPY PROTECT" on turns on the SCMS, thereby blocking digital
copying of the output signal. Place the cursor and turn the switch on or off with [F4].
3
... Word clock source
Specifies the reference device of the word clock (32). Place the cursor, select with the
V1 knob and enter with [F1] (SET).
4
... Word clock in terminator
This switch needs to be turned on if the system is at the end of the word clock, so that
the word clock is transmitted correctly. Place the cursor and turn the switch on or off
with [F3].
5
... Internal sampling rate
Sets the sampling rate (sampling frequency) internally. Sampling rates of 48 kHz,
44.1 kHz, and 32 kHz can be selected. Place the cursor, select with the V1 knob and
enter with [F1] (SET). After operation, some time may be required to finish changing
the settings.
Restoring the Original Factory Settings
(Factory Reset)

Factory reset procedure

Implement the following procedures to return all the parameter values to those set
prior to shipping. Note that implementing factory reset deletes all user settings on
the console.
1. Turn off the console's power.
2. While holding down [PROJECT] and [F1], turn the power on again.
3. When the factory reset screen is displayed, press [F1].
All the parameter values will be returned to those set prior to shipping.
Chapter 1 Introduction
The "SCMS" (Serial Copy
Management System) is a
copyright protection
function for home digital
audio devices, such as MD
recorders. It prohibits
second generation and after
copying with digital
connections.
The volume of connected
amplifiers must be lowered
or amplifier power turned
off.
33