Add Dynamics (Expand) - Roland VM-C7100 Owner's Manual

Chapter 11 Recording/Playing Back Fader or Knob Actions (Automix)

Add dynamics (EXPAND)

Of all data existing in a specified region, that greater than a certain value
(THRESHOLD) can be increased in value, and that smaller than it can be reduced in
value to increase the variation. This function is useful when you want to add
dynamics.
fig.11-10_70
SHIFT
This field specifies the value increment in auto-mixing data.
fig.11-11e
0
RATE
This field specifies the rate at which EXPAND should be applied.
Set RATE at "50" to apply EXPAND at a rate of half the value specified for SHIFT,
and at "200" to apply it at a rate of twice the value.
THRESHOLD
This field sets up the reference value. Values exceeding this value are converted to
even greater values and those below it to even smaller values.
1. Check if the AUTO MIX VIEW screen is displayed (p. 208).
2. Press CURSOR [DOWN] to move the cursor over to the VIEW/SOURCE/
VALUE TRIM section.
3. Press [F6] (EDITMENU).
The EDIT MENU dialog is displayed. To clear the displayed dialog, press [F6]
(EXIT).
4. Press CURSOR [DOWN] to move the cursor to the bottom section in the
dialog.
5. Press [F1] (EXPAND) to display the EXPAND screen.
220
Shift
Time
To obtain the value
specified here, set the value
for RATE at "100."
Specify the region subject
to editing before
attempting to display the
screen for the expand
operation. Without the
region subject to editing set
up, the screen for the
expand operation cannot be
displayed.