Turning The Power On/Off - Roland M-200i V-mixer Owner's Manual

Turning the power on/off

Turning the power on
Once the connections have been completed, turn on power
to your various devices in the order specified. By turning on
devices in the wrong order, you risk causing malfunction
and/or damage to speakers and other devices.
fig.PowerOnOrder.eps
3
INPUT
Cat5e
M-380 M-200i
1.
Connect your input/output units (S-1608, S-0816, S-
4000S, etc.) to the M-200i's REAC port.
2.
Connect your audio equipment to the audio inputs and
audio outputs of the M-200i and your input/output units.
983
Audio feedback could be produced depending on the
location of microphones relative to speakers. This can be
remedied by:
1. Changing the orientation of the microphone(s).
2. Relocating microphone(s) at a greater distance from
speakers.
3. Lowering volume levels.
3.
Turn on the power of the equipment connected to the
audio inputs of the M-200i and your input/output units.
4.
Turn on the power by holding down the POWER switch
located on the M-200i's rear panel for 1 second or longer.
Wait for appearance of the V-Mixer logo.
When the power supply has started up, a screen like the
following will appear:
fig.ScrMeter.eps
In this screen you can specify whether the auto off function (p.
111) will be enabled or disabled.
If you move the cursor to OFF (DISABLE "AUTO OFF") and press
[ENTER], the auto off function will be disabled.
5 6
OUTPUT
4
If you move the cursor to 8 HOURS (ENABLE "AUTO OFF") and
press [ENTER], the auto off function is kept enabled.
This screen will not appear if the auto off function is turned
"OFF"
5.
Turn on the power of your input/output units.
For information about how to turn the power of attached REAC
devices on, refer to the owner's manual of the REAC device.
6.
Turn on the power of the equipment connected to the
audio outputs of the M-200i and your input/output units.
942
This unit is equipped with a protection circuit. A brief interval
(a few seconds) after power up is required before the unit
will operate normally.
Before switching the power on/off, always be sure to turn
the volume down. Even with the volume turned down, you
might hear some sound when switching the power on/off.
However, this is normal and does not indicate a malfunction.
With the factory settings, the M-200i's power will
automatically be switched off 8 hours after you stop playing
or operating the unit. If you don't want the power to turn off
automatically, change the "AUTO POWER OFF" setting to
"OFF"as described on p. 111. The settings you were editing
will be lost when the power is turned off. If you want to keep
your settings, you must save your settings before turning the
power off.
Turning the power off
1.
Turn off the power of the equipment connected to the
audio outputs of the M-200i and your input/output units.
2.
Turn off the power by holding down the POWER switch
located on the M-200i's rear panel for 1 second or longer.
Wait for the POWER OFF message.
3.
Turn off the power of your input/output units.
For information about how to turn the power of attached REAC
devices on, refer to the owner's manual of the REAC device.
4.
Turn off the power of the equipment connected to the
audio inputs of the M-200i and your input/output units.
921
Before you turn off the power of the M-200i, make sure that
it is not reading/writing USB memory or reading/writing
scene memory or library data. The data may be lost if you
turn off the power during such operations.
To prevent malfunction and/or damage to speakers or other
devices, always turn down the volume, and turn off the
power on all devices before making any connections.
Introduction
15