Copying (Copy) - Roland VM-C7100 Owner's Manual

Chapter 11 Recording/Playing Back Fader or Knob Actions (Automix)

Copying (COPY)

This function is used to copy data in a specified region to another time position or
another channel.
fig.11-04_70
IN/OUT
These fields display the region of the data to be copied. The value of REGION SET
(p. 211) indicates the region to be copied.
FROM
This field sets the reference position in the data to be copied. The position specified
here is copied to the position specified in the TO field.
TO
This field sets up the position to which data is to be copied.
DESTINATION
This field sets up the channel to which data is to be copied. The destination channel
is marked with the letter "D."
INSERT ON
This field specifies the copying method. To copy by overwriting, set this to "OFF."
To copy by insertion, set to "ON." In this case, data following the point specified
with TO is placed after the inserted data.
TIMES
This field specifies how many times data is to be copied.
1. Check if the AUTO MIX VIEW screen is displayed (p. 208).
2. Press CURSOR [DOWN] to move the cursor over to the VIEW/SOURCE/
VALUE TRIM section.
3. Press [F6] (EDITMENU).
The EDIT MENU dialog is displayed. To clear the displayed dialog, press [F6]
(EXIT).
4. Press CURSOR [UP] to move the cursor to the top section in the dialog.
5. Press [F1] (COPY) to display the COPY screen.
6. Press CURSOR [DOWN] to move the cursor to the bottom section on the
screen.
212
Copying will never result
in placing data before
00:00:00.00 or after
24:00:00.00.
Only one value can be set
for DESTINATION. To
copy data on more than
one channel at a time,
specify the destination
channel with the smallest
number. Since the
destination channels are
assigned for copying, they
correspond to the source
channels. For example, if
the source channels are
Channels 1, 2, 5 and 6,
setting DESTINATION at
"7" causes the data to be
copied to Channels 7, 8, 11
and 12. You cannot set
DESTINATION to any
channels that do not
correspond to the source
channels. For example, you
cannot specify Channels 21
to 24 as the destination
channels if the source
channels are Channels 20
and 24.
Specify the region subject
to editing before
attempting to display the
screen for the copy
operation. Without the
region subject to editing set
up, the screen for the copy
operation cannot be
displayed.