Settings For The Panel (Knobs And Display) - Roland VM-C7100 Owner's Manual

Settings for the Panel (Knobs and Display)

Here, you can use the buttons or foot switch to make settings affecting the operation
of the unit.
1. While holding down [SHIFT], press [PROJECT].
2. Press CURSOR [UP], then press [F3] (FADER/BUTTON).
The SYSTEM FADER/SW screen shown below is displayed.
fig.02-05
1
4
7
8
1
PAN CURVE TYPE
Depending on the sound location, the volume may be unstable. This setting is used
to correct such unstable sound volumes. Normally, it is set at -3 dB. When it is set at
0 dB, no sound volume adjustment is performed.
fig.02-06
LEVEL
0dB
LEFT
2
PREAMP GAIN ADJUST MODE
To ensure high quality sound, input gain is adjusted in this system using an
electronic relay method rather than VCA.
• NOISELESS:
• CONTINUOUS: No special processing is carried out when relays are switched,
3 FADER MOTION DEMO
Performs demonstration to check the fader motion.
4
SHIFT LOCK
Normally, the [SHIFT] button only functions while it is being pressed. When it is set
to "LOCK," the [SHIFT] button keeps functioning while the [SHIFT] indicator is on.
To release this function, press the [SHIFT] button again to turn the indicator off.
When you frequently need to use [SHIFT], the "LOCK" setting is very convenient.
Chapter 2 Basic Operations and Their Settings (System/Project)
2
5
LEVEL
-3dB
0dB
CENTER RIGHT LEFT
Volume is controlled, and noise in relay switching is reduced.
thus preventing interruption of the sound.
3
6
0dB
CENTER RIGHT
Depending on the
connected device, direct
current voltage may be
contained in the signal,
which may result in noise
during gain switching. In
such cases, set the system
to "NOISELESS."
37