Re-Recording The Specified Section (Punch In) - Roland VM-C7100 Owner's Manual

Chapter 11 Recording/Playing Back Fader or Knob Actions (Automix)

Re-recording the specified section (PUNCH IN)

To re-record part of existing auto-mixing, use the PUNCH IN function. Either
absolute recording or relative recording can be used.
Manually specify the region subject to re-recording (MANUAL PUNCH IN)
The region subject to recording can be specified by switching the channel to the
recording state while playing back auto-mixing.
1. Press any of the buttons in SECTION to select one of the sections.
2. Press [AUTO-MIX] to set it to ABSOLUTE RECORDING (red indicator) or
RELATIVE RECORDING (orange indicator).
3. Press [AUTO-MIX] under CH STATUS.
4. Press the status button for the channel for which auto-mixing is to be re-
recorded to set it to the playback state (green indicator).
Also, set other channels to playback state.
5. Press any of the buttons in "PARAMETER VIEW on Fader" to select the
type of settings to be recorded.
6. Press [PLAY] to start playing back auto-mixing.
The channel of the status button with the green indicator starts playback.
7. As the section to be re-recorded approaches, press the status button for the
channel for to set it to the recording state (red indicator).
8. Operate the faders or knobs to record the data.
9. Press the status button for the channel to set it to the playback state (green
indicator), after you finish recording.
10.Press [STOP] to stop playback.
Specifying the region by using the Locator (AUTO-PUNCH IN)
Specify the region to be re-recorded with the Locator beforehand, then re-record the
auto-mixing settings.
1. Press [LOCATE] while holding down [SHIFT] to display the LOCATE
screen.
2. Press [PAGE DOWN] to display the SETUP screen for the Locator.
3. Press CURSOR [DOWN] to move the cursor over to the AUTO PUNCH
section.
4. Press [F1] (ON) to set the AUTO-PUNCH IN function on.
5. Turn the V3 (START) knob to set up the recording start position.
To move the cursor on the hour, minute, second or frame, press
[RIGHT]
while holding down [SHIFT].
206
Press [UNDO/REDO] to
cancel the auto-mixing just
recorded (UNDO). Pressing
[UNDO/REDO] once more
restores the auto-mixing
just recorded (REDO).
On/off auto punch-in
switching can also be done
by using the [COPY/
LIBRARY] while holding
down [SHIFT].
To set the recording start
CURSOR [LEFT]/
position to the current
position, press [F3] (NOW).