Operation For Producing An Effect; Determining The Effect Position - Roland VM-C7100 Owner's Manual

Chapter 8 Using the Internal Effects

Operation for Producing an Effect

Determining the effect position

You can assign effects to the signal paths shown in the block diagram on a separate
sheet (provided with the processor). Note that the positions to which the effects are
assigned are limited for each effects processor.
You can only assign effects to the locations checked on the chart shown
below.
fig.08-001e
(Position)
INPUT
(MULTI IN)
OUT
FLEX
Internal
BUS
MAIN OUT (L,R)
MONITOR OUT (L,R)
(Position)
Occupies Flex Bus 1.
SEND RETURN
fig.08-add1
110
*1 Either INPUT or MULTIIN can be selected on an expansion board basis.
FX1 FX2 FX3 FX4 FX5 FX6 FX7 FX8 Master FX
(EFFECT)
1–4
13–16
5–8
17–20
9–12
21–24
1–12
1–2
3–4
5–6
7–8
Standard Expansion [A] Expansion [B] Expansion [C]
(EFFECT)
FX1 FX2 FX3 FX4 FX5 FX6 FX7 FX8 Master FX
Occupies Flex Bus 2.
Occupies Flex Bus 3.
Occupies Flex Bus 4.
Occupies Flex Bus 5.
Occupies Flex Bus 6.
Occupies Flex Bus 7.
*1
Standard
Occupies Flex Bus 8.
As for effects A (3/4), B
(5/6) and C (7/8), added
by means of the VS8F-2,
you must select their use
for Input or MultiIn when
you use them for channel
insertion. This setting is
available from the screen
shown below (system "FX
MISC" page).
How to call up the screen
[EFFECTS 1-8] CURSOR
[DOWN] (bottom line)
[F6] (JUMP)