Roland VM-C7100 Owner's Manual page 122

Parameter (full name)
3 BAND EQ (Equalizer)
Sw (Switch)
Hi Gain (High Gain)
Hi Freq (high frequency)
Hi Q (High Q)
Hi Type (High Type)
Mid Gain (Middle Gain)
Mid Freq (middle frequency)
Mid Q (Middle Q)
Lo Gain (Low Gain)
Lo Freq (low frequency)
Lo Q (Low Q)
Lo Type (Low Type)
Output Level (Output Level)
Reverb:
Room-Size (Room Size)
Time (Reverb Time)
Pre-Delay (Pre-Delay)
Difusi (Diffusion)
Density (Density)
LoFreq-Damp Gain (LF-Damp Gain)
LoFreq-Damp Freq (LF-Damp Frequency)
HiFreq-Damp Gain (HF-Damp Gain)
HiFreq-Damp Freq (HF-Damp Frequency)
HiCut Freq (High Cut Frequency)
Effect Level (Effect Level)
Direct Level (Direct Level)
ErlyRef Level (Early Reflection Level)
*1: If Low Type (Lo Type) or High Type (Hi Type) is set to "Shelv (Shelving Type)," the setting for Lo Q or High Q
is invalid.
Frequency (p. 237), Q (p. 243), Shelving Type (p. 244), Peaking Type (p. 242), Equalizer (p. 236), Reverb (p. 244)
Setting
On, Off
-12– +12 dB
1.4–20.0 kHz
0.3–10.0
Shelv, Peak
-12– +12 dB
200–8000 Hz
0.3–10.0
-12– +12 dB
20 - 2000 Hz
0.3–10.0
Shelv, Peak
0–100
Adds reverberation.
5–40 m
0.1–32.0 sec.
0–200 ms
0–100
0–100
-36–0 dB
50–4000 Hz
-36–0 dB
1.0–20.0 kHz
0.2–20.0 kHz
-100–100
-100–100
0 to100
Chapter 8 Using the Internal Effects
Function
Turns the equalizer on or off.
Sets the boost/cut amount in the high frequency band.
Sets the center frequency in the high frequency band.
Sets the width of the area around the high frequency that
will be affected by the gain settings.1
Sets the type of the high frequency band equalizer
(shelving type or peaking type).
Sets the boost/cut amount in the middle frequency band.
Sets the center frequency in the middle frequency band.
Sets the width of the area around the middle frequency that
will be affected by the gain settings.
Sets the boost/cut amount in the low frequency band.
Sets the center frequency in the low frequency band.
Sets the width of the area around the low frequency that
will be affected by the gain settings.1
Sets the type of the low frequency band equalizer
(shelving type or peaking type).
Sets the volume after passing through the equalizer.
Sets the size of the room.
Sets the time length of the reverb sound.
Sets the time until the reverb sound appears.
Sets the extent of diffusion of the early reflection sound.
Sets the density of the reverb sound.
Sets the degree of attenuation of the reverb in the low
frequency band.
Sets the frequency on which the reverb starts attenuating in
the low frequency band.
Sets the degree of attenuation of the reverb in the high
frequency band.
Sets the frequency on which the reverb starts attenuating in
the high frequency band.
Sets the frequency for which the high frequency band
elements of the reverb are cut.
Sets the volume of the reverb sound.
Sets the volume of the direct sound.
Sets the volume of the early reflection.
*1
*1
121