E: Fader Parameter/Section Select Area; Preamp Gain Button; On Display Button; Param View On Fader Buttons - Roland VM-C7100 Owner's Manual

E: Fader parameter/Section select area

fig.01-6
1
2
3
4
5

1...PARAM VIEW on Fader buttons

These buttons determine the type of parameters—such as
Input, Multi In, Flex Bus, or Multi Out parameters—to be
displayed. The displayed parameters' values can be set
using the faders and/or a variety of other methods.
Press [OTHER PARAMETERS] to present the settings of a
specific parameter for all channels simultaneously. For
example, you can display and adjust the EQ HI GAIN
parameters values for all 24 input channels at the same
time. When active, the OTHER PARAMETERS button will
light in red. When you press [OTHER PARAMETERS], a
selection of parameters appropriate to the currently
selected section will be displayed. You can use the cursor
to select the parameter you wish to display. Press [OTHER
PARAMETERS] together with [SHIFT] to view a second
display containing the same parameters—you can select
another parameter here and toggle the display between
the two selected parameters by pressing [OTHER
PARAMETERS] or [OTHER PARAMETERS] and [SHIFT].
* These features are available only with certain
parameter sections.
2...FLEX BUS 1–6/7–12 buttons
6
Press any of the FLEX BUS 1–6 buttons to display and
adjust each Flex Bus's settings that correspond to the
currently selected parameter section. To access the
7
parameters for Flex buses 7 through 12, hold down
[SHIFT] and press the desired 7–12 FLEX BUS button.
8

3...PREAMP GAIN button

Press this button to set the input preamplifier gain for each
9
channel using its fader.
After this button is pressed together with [SHIFT], the
10
depth for the Surround output of each channel can be set
using the fader or on the display.
11
4...(MAIN) CH PAN button
Press this button to activate the adjustment of each
12
channel's fixed pan position, according to the currently
selected section button. Press this button together with
13
[SHIFT] use the fader or display to set the pan of the
signals to be sent to the Cue bus.
14
5...(MAIN) CH LEVEL button
Press this button to activate the adjustment of each
channel's level, according to the currently selected section
button. Press this button together with [SHIFT] to activate
each channel's fader, or the display, for setting the level of
the channel's signal being fed to the Cue bus.

6...On Display button

When [On Display] is pressed—so that it lights up—the
channel faders are locked into controlling the currently
selected parameter. As long as [On Display] remains lit,
the faders will continue to control this parameter. When
the display is changed to another screen, [V1] to [V6] can
adjust the value of any newly selected parameter. This
allows you to adjust one parameter with the faders and
another with the V knobs.
7–14...SECTION buttons
These buttons determine the type of parameters to be
displayed, and the values that can be changed.

7...2nd UNIT select button

Press this button to activate control of the cascaded (23)
second mixing processor. This button can be turned on in
conjunction with another section-selecting button in order
to display the desired set of parameters on the second
processor.
* The on/off state of this button identifies the processor
whose parameter values are currently being adjusted—
"1st UNIT" refers to the processor connected to the
console via the VM link, while "2nd UNIT" refers to
the processor cascading from it.
Chapter 1 Introduction
17