Playing Back Auto-Mixing - Roland VM-C7100 Owner's Manual

6. Turn the [V5] (END) knob to set up the recording finish position.
To move the cursor on the hour, minute, second or frame, press
[DOWN]
/[UP] while holding down [SHIFT].
7. After step 6, follow the same steps as for RELATIVE RECORDING (p. 205)
or for ABOSOLUTE RECORDING (p. 204).
The auto-mixing is automatically set to the recording state at the recording start
position. All operations on the Fader are recorded. The auto-mixing automatically
exits the recording state at the recording finish position.
8. Press [STOP] to stop playback.

Playing Back Auto-mixing

To synchronize with an external device
Playback of auto-mixing starts upon reception of time code. To play back auto-
mixing on this unit alone, press [PLAY] and time code is generated internally. To
play back auto-mixing in synchronization with an external device such as an MIDI
sequencer or multitrack recorder, time code is sent from such devices.
Playback of auto-mixing is terminated as time code stops being received. When
playing back auto-mixing on this unit alone, press [STOP] and internal generation of
time code is terminated. When playing back auto-mixing in synchronization with
any external devices, stop sending time code from those devices.
As you can see from the above explanation, it is necessary to determine which
timecode to sync to beforehand. Set [EXT SYNC] on to sync to timecode from an
external device and set [EXT SYNC] off to sync to internal timecode.
1. Press any of the buttons in SECTION to select one of the sections.
2. Press [AUTO-MIX] to set it to the playback status (the indicator: green).
3. Press [AUTO-MIX] under CH STATUS.
The status button for the channel is switched to the mode for operating for auto-
mixing.
4. Press the status button for the channel for which auto-mixing is to be
played back to set the channel to the playback status (the indicator: green).
5. Press [PLAY] to start playing back the auto-mixing.
The channel of the status button with the green indicator starts playback.
6. Operate the faders or knobs to adjust mixing.
Fader or knob operation supersedes the recorded auto-mixing data.
7. Press [STOP] to finish playing back auto-mixing.
Chapter 11 Recording/Playing Back Fader or Knob Actions (Automix)
CURSOR
To set the recording finish
position to the current
position, press [F5] (NOW).
Press [UNDO/REDO] to
cancel the auto-mixing just
recorded (UNDO). Pressing
[UNDO/REDO] once more
restores the auto-mixing
just recorded (REDO).
The channel of the status
button with the red
indicator light also starts
playback when data have
been already recorded. The
Fader, however, will not
move.
207