Turning The Talkback And Slate Features On And Off Independently - Roland VM-C7100 Owner's Manual

Turning the talkback and slate features on and off
independently
You can select the talkback and slate destinations for the signal captured by the
talkback microphone by setting the TALKBACK and SLATE parameters.

Turning the talkback and slate features on and off independently

1. Press [TALKBACK/SLATE] while holding down [SHIFT].
This calls up the talkback/slate screen (TALKBACK).
2. Press CURSOR [UP] to select the upper section (MODE, SEND TO MAIN/
CUE).
fig.06-31
3. Select either TALKBACK or SLATE.
Turn the V1 knob to select either one and press [F1] (SET) to confirm your selection.
The screen will change to reflect your choice.
4. Turn the talkback or slate send to MAIN OUT, cue bus and MONITOR
OUT on or off.
Press [F3] (MAIN) or [F4] (CUE) to toggle the respective send on or off.
5. Turn the talkback or slate send to MULTI OUTs, (ASSIGNABLE OUT/
DIGITAL OUT A, B) on or off.
Use CURSOR [UP] or [DOWN] to select the desired set of six MULTI OUTs
(ASSIGNABLE OUT/DIGITAL OUT). Press [F1] to [F6] to toggle the send to each
output on or off.
fig.06-32
6. Turn the talkback or slate send to Flex Buses on or off.
Press CURSOR [UP] or [DOWN] to select FLEX Buses 1 to 6 or 7 to 12 in the lower
section of the screen. Press [F1] to [F6] to toggle the send to each Flex Bus on or off.
fig.06-33
Chapter 6 Mixing Procedure 2 (Output and Monitor)
When [TALKBACK/
SLATE] is pressed, the
microphone's signal is sent
to the destination selected
in Step 3 below.
Selecting SEND LEVEL at
the lower right corner with
the cursor allows you to
adjust the talkback or slate
volume using the V6 knob.
101