Band Graphic Equalizer - Roland VM-C7100 Owner's Manual

31 Band Graphic Equalizer

This Graphic Equalizer allows setting at 31 points. Each point is a frequency of a multiple of 20, 25 or 31.5 within
the range from 20 Hz to 20 kHz.
fig.08-83
Input A
Input B
31-Band Graphic Equalizer can be used only with FX-1, FX-3, FX-5 and FX-7.
Controlling Channels A and B separately
Setting Link On enables simultaneous control on the 31-Band Graphic Equalizer via Channel B according to the
settings on the Channel A side.
To control Channels A and B separately, turn Link Off.
Parameter (full name)
Link:
Link (Link Switch)
BassCut ch A/ch B (Bass Cut Filter): Cuts off undesired low sounds such as pop noise.
Sw (Switch)
Freq (Frequency)
31 Band EQ ch A/ch B (31-Band Graphic Equalizer)
Sw (Switch)
Input Level (Input Level)
Output Level (Output Level)
Band 1 - 31 Gain (Bands 1 - 31 Gain)
• To switch the band, turn the V4 (BAND) knob, or press [F4] (BAND-) or [F5] (BAND+).
• When returning the input level, the output level, and the gain of each band to 0, press [F3] (ALL RST).
Bass Cut Filter (p. 233), Graphic Equalizer (p. 237)
BAS-CUT A 31BAND EQ A
Link
BAS-CUT B 31BAND EQ B
Setting
Channel B follows the settings for Channel A.
On, Off
On, Off
Thru, 20 - 2000 Hz
On, Off
-30.0– +15.0 dB
-30.0– +15.0 dB
-15.0– +15.0 dB
Chapter 8 Using the Internal Effects
Output A
Output B
Function
Specifies if Channel B follows or does not follow the
settings for Channel A.
Turns the bass cut filter on or off.
Cuts off undesired low frequency band sounds such as pop
noise.
Turns the 31-band graphic equalizer on or off.
Sets the overall volume before passing through the
equalizer.
Sets the overall volume after passing through the equalizer.
Sets the boost/cut amount by frequency.
175