Recording Auto-Mixing; Clearing The Memory (Clear) - Roland VM-C7100 Owner's Manual

Recording Auto-mixing

By recording auto-mixing, a variety of sequential settings can be recorded, including
volume balance between channels, alignment of panning and fading in/out.
To synchronize with external devices
To operate this unit to music recorded in an external sequencer or on a multitrack
recorder, refer to "Setup for Synchronized Operation with Recorder" (p. 196)
before you start.
Recording of auto-mixing starts upon reception of the timecode. To record auto-
mixing on this unit alone, press [PLAY] and timecode is generated internally. To
record auto-mixing in synchronization with an external device, such as a MIDI
sequencer or multitrack recorder, the timecode is sent from the respective devices.
Recording of auto-mixing is terminated when the timecode stops being received.
When recording auto-mixing on this unit alone, press [STOP] and the internally
generated timecode is terminated. When recording auto-mixing in synchronization
with an external device, stop sending the timecode from that device.
As you can see, it is necessary to determine which timecode to sync to beforehand.
Set [EXT SYNC] on to sync to the timecode from an external device and set [EXT
SYNC] off to sync to the internal timecode.

Clearing the memory (CLEAR)

Auto-mixing is recorded in the internal memory. To record a new set of auto-mix
when another set of auto-mix has already been recorded, clear the internal memory
by following the steps below.
1. Press [AUTO-MIX] while holding down [SHIFT].
The base screen for auto-mixing, VIEW, is displayed.
2. Press [PAGE UP] to move the cursor to "VIEW."
3. Press CURSOR [UP] to move the cursor to the bottom section on the screen.
4. Press [F6] (EDITMENU).
The edit menu dialog for auto-mixing is displayed.
5. Press CURSOR [DOWN] to move the cursor to the bottom section in the
dialog.
6. Press [F2] (CLEAR) to display the CLEAR screen.
7. Press CURSOR [DOWN] to move the cursor over to the CLEAR section.
8. Press [F4] (EXEC) to clear the memory.
When the memory is cleared, a "Complete" message is displayed.
9. Press [F6] (RETURN) and [F6] (EXIT), in this order, to return to the VIEW
screen.
Chapter 11 Recording/Playing Back Fader or Knob Actions (Automix)
It is not possible to record
auto-mixing on the edit
screen, including such
operations as copy and
move, or on the base screen
(VIEW screen).
Data types for which
RECORDABLE
PARAMETER on the
SETUP screen is set to off
cannot be recorded.
To abort clearing of the
memory, press [F6] (EXIT).
203