Automix And Channel Statuses - Roland VM-C7100 Owner's Manual

1. Press [AUTO-MIX] while holding down [SHIFT].
2. Press [PAGE UP]/[PAGE DOWN] to display the SETUP screen.
3. Press CURSOR [DOWN] to move the cursor to the INITIAL SCENE/
REMOVE FOLLOW DATA section.
4. Press [F1] (SEL) to set Automix in the playback/recording start status.
To start with the current status, set to "NO SCENE." To start with one of the
recorded scenes, set to "SCENE" and select the scene number by turning [V1]
(INITIAL SCENE).
5. Indicate if the Automix previously recorded are to be reserved or not by
pressing [F2] (SEL).
With each press of [F1] (SEL), the display cycles through the selections of "OFF," TO
NEXT LOC," and "TO END DATA."
6. Press CURSOR [DOWN]/[UP] to move the cursor to the RECORDABLE
PARAMETER section.
7. Press [F1] to [F6] to indicate if the respective data is to be recorded or not.

Automix and channel statuses

Automix can be done in any of the four states: Off, Playback, Absolute Recording,
and Relative Recording. Also, each of the Playback, Recording and Off states can be
set for each channel respectively. Cleverly combining these states enables the
Automix function to be used effectively.
Statuses of Automix
Automix can be done in any of the following four states. These states can be switched
by pressing [AUTO-MIX]. You can check the status with the indicator. Select one
most suitable for the desired operation.
Automix status
No to use the auto-mixing function (Off).
To play back:
To record operations as they are (Absolute Recording)
To make relative changes (Relative Recording)
fig.11-02a
Chapter 11 Recording/Playing Back Fader or Knob Actions (Automix)
Indicator
Turned off.
Green
Red
Orange
If Automix in the
Absolute/Relative
Recording state, data can
only be recorded on the
channel in the Recording
state. In any other states,
data is not recorded.
The auto-mix status cannot
be switched while
recording/playing back
auto-mixes.
201