Roland VM-C7100 Owner's Manual page 113

Chapter 8 Using the Internal Effects
6. Specify the position to which the effect is to be assigned.
Using the V2 knob (POSITION), select one of the following. (For the master effect,
you can select OFF, MAIN or MONITOR with the V1 knob.)
• OFF
• INPUT PRE EQ
• INPUT PRE FDR
• MULTI IN PRE EQ
• MULTI IN PRE FDR
• SEND/RTN (INT)
• INT FBUS
• EXT FBUS
• MAIN
• MONITOR
7. Specify the channel to which the effect is to be inserted (*).
Select the channel number with the V1 knob (CHANNEL SELECT) and then press
[F1] (SET) to validate your choice. It is possible to set the channels only when their
numbers are provided (e.g., INPUT, FLEX BUS, etc.)
* This step is not required for the master effect.
Other restrictions
• You can only select the following algorithms with effects 1, 3, 5 and 7. And since
they require a larger signal processing circuit and, thus, the subsequent one (e.g.,
FX2 for FX1, FX4 for FX3, and so on) cannot be used at the same time.
Voice Transformer
Vocoder2
Mastering Tool Kit
31-Band Graphic Equalizer
• When a spectrum analyzer is being used (p. 184), a predefined set of effects, 1
and 2, 3 and 4, 5 and 6, or 7 and 8, is not available. This is because the built-in
spectrum analyzer shares the processing circuit with effects 1 to 8. The
unavailable effects are then switched to a bypass state (output as input sound).
The effect processing circuit to be shared with the analyzer is set in the SETUP
page on the Analyzer screen. Use [ANALYZER/OSC/GEN] and [PAGE
(DOWN, UP)] to invoke the screen (p. 185).
112
Not used.
Inserted to an INPUT channel (pre-equalizer).
Inserted to an INPUT channel (pre-fader).
Inserted to a MULTI IN channel (pre-equalizer).
Inserted to a MULTI IN channel (pre-fader).
To be used in an image of Send/Return to the effect.
Inserted to a Flex Bus (internal mode).
Inserted to a Flex Bus (external mode).
Inserted to MAIN OUT.
Inserted to MONITOR OUT.