Editing Auto-Mixing; Confirming Data (View) - Roland VM-C7100 Owner's Manual

Chapter 11 Recording/Playing Back Fader or Knob Actions (Automix)

Editing Auto-mixing

The respective auto-mixing settings are referred to as "data." You can edit auto-
mixing by overwriting these values.

Confirming data (VIEW)

You can confirm the data on the AUTO MIX VIEW screen. This is the base screen for
editing auto-mixing.
fig.11-03
1
VIEWER area
You can check data by channel by viewing this area.
On the left, the channel numbers and names (abbreviated) are displayed. In addition,
the channel subject to editing (source channel) is marked with the letter "S,"
channels to which some data is copied or moved (destination channels) are marked
with the letter "D." In the graphics section, data is displayed by channel.
2 PAGE section
Use this section to switch the page.
VIEW:
SETUP:
STAT1_U1:
STAT1_U2:
STAT2_U1:
STAT2_U2:
3
ZOOM section
This section can be used to scale up/down the graphics display in the VIEWR area.
4
REGION SET section
This section is used to set up the region of the auto-mixing to be edited.
208
1 9 8
5 6
the screen for confirming data
settings related to auto-mixing
Screen 1 for confirming the channel status
Screen 2 for confirming the channel status
Screen 1 for confirming the channel status of a second
processor connected in cascade.
Screen 2 for confirming the channel status of a second
processor connected in cascade.
2
3
4
7