Setting Parameters - Roland VM-C7100 Owner's Manual

Setting parameters

To set parameter values, move the cursor to the target parameter, then set the
parameter values using the V1 to V6 knobs/fader/[F1] to [F6].
Moving the cursor
The cursor is used for grouping some parameters together as modification targets.
To move the cursor, press either CURSOR [UP], [DOWN], [LEFT] or [RIGHT].
fig.02-02
Changing values
The method of changing values varies depending on the parameter. The following
rules apply, so keep them in mind.
The value of parameters marked
The value of parameters marked
[F6] on (highlighted) or off (normal indication).
The value of parameters marked
knobs to select the value and pressing either of the [F1] (SET) to [F6] (SET) having the
same number to determine it.
(You can directly modify some parameters with [F1] to [F6] (SET).)
The value of parameters with a fader indicated can be changed by the fader. When
the cursor is placed at the fader, the value can also be changed by turning the V1 to
V6 knobs.
Chapter 2 Basic Operations and Their Settings (System/Project)
can be changed by turning the V1 to V6 knobs.
can be changed by switching the [F1] to
can be set by turning either of the V1 to V6
Pressing CURSOR [LEFT]
or [RIGHT] while holding
down [SHIFT] changes the
unit (hour, minute, second,
or rate) for changing the
current position.
35