Chapter 6 Mixing Procedure 2 (Output And Monitor); Setting Master Mix Levels And Stereo Balance; Setting The Master Levels For The Main Outs And Cue Bus - Roland VM-C7100 Owner's Manual

Chapter 6 Mixing Procedure 2 (Output and Monitor)

This system provides a variety of output types: MAIN OUTs, MONITOR OUTs,
ASSIGNABLE OUTs and two stereo digital audio outputs. In addition, when a VM-
24E (purchased separately) is installed, 24 MULTI OUT connections—utilizing three
R-BUS terminals—become available. The VM-7200 mixing processor adds an
additional eight independent Flex Bus outputs.
This chapter describes using these outputs.

Setting Master Mix Levels and Stereo Balance

Each input and multi-in channel can be routed into the main mix, which sends its
audio out of the system through the MAIN OUT outputs. You can adjust the
channel's send into the main mix, as well as its stereo pan position within the mix.
You can also send the desired amount of signal from each channel to the cue bus.
Setting the master levels for the MAIN OUTs and cue
bus
The master MAIN OUT and cue bus level and stereo balance controls affect the
overall level and balance of all signals sent to the main mix or cue bus from input or
multi-in channels. They can be set using the master fader—the fader with the red
handle.
Setting the MAIN OUT master level and stereo balance
1. Press [INPUT] or [MULTI IN] in the SECTION area.
2. Call up the MAIN OUT level setting by pressing [CH LEVEL] in the
PARAM VIEW on Fader area so that the button turns red.
3. Use the master fader to set the MAIN OUT master level.
fig.06-01
4. Call up the MAIN OUT stereo balance setting by pressing [CH PAN] in the
PARAM VIEW on Fader area so that the button turns red.
5. Use the master fader to set the MAIN OUT master stereo balance.
Setting the master level of the cue bus
1. Press [INPUT] or [MULTI IN] in the SECTION area.
2. Call up the cue bus master level setting by pressing [CH LEVEL] (CUE
LEVEL) beneath the master fader while holding down [SHIFT].
The CH LEVEL button turns green.
84
To learn how to establish
proper output connections,
refer to the block diagram
attached to the mixing
processor.
The master fader controls
the MAIN OUT left/right
stereo level balance when
[CH PAN] is pressed.