Changing Data One By One (Micro Edit); Defining The Region Subject To Editing - Roland VM-C7100 Owner's Manual

Changing data one by one (MICRO EDIT)

Values such as those for the volume and panning can be changed one by one.
MICRO EDIT is ideal for detailed editing.
You can also use this function to move data one by one. However, if you are
relocating data in a bundle, it is more convenient to use MOVE (p. 214).
1. Check if the AUTO MIX VIEW screen is displayed (p. 208).
2. Press CURSOR [DOWN] to move the cursor over to the VIEW/SOURCE/
VALUE TRIM section.
3. When more than one processor is connected, press [F1] (2NDUNIT) to
select the processor.
4. Turn the [V1] (SECTION) knob to select a section.
5. Turn the [V2] (PARAM) knob to select the data type to be changed.
6. Turn the [V3] (SOURCE) knob to select the channel storing the data you
want to change.
7. Turn the [V4] (EVENTSEL) knob to select the data to be changed.
8. To change the data, turn the [V6] (VALUE) knob. To move the data, turn
the [V5] (TIME) knob to specify the new location, then press [F5] (EXEC).

Defining the region subject to editing

For the copy, move and erase operations, you can edit the data in a specified region
en masse. You can also edit data stored on more than one channels en masse. Such
region from the edit start position to the edit finish position is referred to as
"REGION SET" and a channel subject to editing, "SOURCE CHANNEL."
1. Check if the AUTO MIX VIEW screen is displayed (p. 208).
2. Press CURSOR [DOWN] to move the cursor over to the VIEW/SOURCE/
VALUE TRIM section.
3. Turn the [V3] (SOURCE) knob to select the channel subject to editing, then
press [F3] (SET).
To the left of the channel number, "S" is displayed, indicating that it is a source
channel.
4. Press CURSOR [DOWN]/[UP] to move the cursor to the REGION SET
section.
5. Turn the TIME/VALUE dial to set the current position to the position to
start editing.
Turning the TIME/VALUE dial shifts the current position by either hour, minute,
second or frame unit. To change the unit, press
holding down [SHIFT].
6. Press [F5] (IN) to assign the current position to the edit start position.
7. Turn the TIME/VALUE dial to set the current position to the position to
finish editing.
8. Press [F6] (OUT) to assign the current position to the edit finish position.
Once the region to be edited is finalized, it is reverse-displayed in the VIEWER area.
Chapter 11 Recording/Playing Back Fader or Knob Actions (Automix)
CURSOR [DOWN] or [UP]
Specify the region subject
to editing before
attempting to display the
screen for the relevant
operation. Without the
region subject to editing set
up, the screen for any
operation cannot be
displayed.
REGION SET can also be
set up on the screen for
each operation, but only
one REGION SET can be
recorded. For example, if
REGION SET is changed
on the copy screen, the
REGION SET settings will
be overwritten on all the
other screens.
It is also possible to make
the position specified with
the locator the edit start
position. Instead of the
TIME/VALUE dial, press
the LOCATE button to shift
the current position.
Pressing [F5] (IN) while
while
holding down [SHIFT] sets
the edit start position to be
set at 00:00:00.00]. Pressing
[F6] (OUT) while holding
down [SHIFT] sets the edit
finish position at
[23:59:59.29] (assuming
there are 30 frames). To
include all the data in the
region subject to editing, it
is a good idea to perform
both of these operations.
211