Setting Up A Monitor For The Mixing Engineer - Roland VM-C7100 Owner's Manual

Chapter 6 Mixing Procedure 2 (Output and Monitor)
Selecting the STUDIO 1 or 2 source signal (source select)
1. Press [SOURCE/STUDIO2].
The STUDIO1/2 screen appears.
fig.06-21
2. Select STUDIO 1 or 2 using [PAGE UP] or [PAGE DOWN].
3. Select the desired source signal for STUDIO 1 or 2.
Turn [V1] (SOURCE SELECT) to select one of the following:
• INPUT CHs 1 to 24
• Flex Buses 1 to 12
• Cue buses L and R
• Monitors L and R
• Mains L and R
Setting the STUDIO 1 and 2 send level
1. Press [SOURCE/STUDIO2].
The STUDIO1/2 screen appears.
2. Select STUDIO 1 or 2 using [PAGE UP] or [PAGE DOWN].
3. Turn [V2] (LEVEL) to set the desired send level.

Setting Up a Monitor For the Mixing Engineer

A mixing engineer can monitor the system using a MONITOR jack on the console:
DIGITAL OUTs 1 and 2, or LINE OUT. The same signals can be heard through
headphones connected to the PHONES jack. They can also be sent to the MONITOR
OUT jack of the VM-7200 processor.
96
You can insert certain
effects—such as
equalization or speaker
modeling—in the monitor
output signal path (p. 110).