Sending Flex Bus Signals To Internal Destinations - Roland VM-C7100 Owner's Manual

The Flex Bus is now set to use an external output.
To use the VM-7100—which does not provide FLEX BUS OUT jacks—or output
signals from Flex Buses 1 to 4, select a MULTI OUT or ASSIGNABLE OUT as
follows:
Selecting a Flex Bus's output
1. Call up a Flex Bus's MAIN/CUE page as described in Step 3 in the
previous section.
2. Press CURSOR [UP] to select a parameter in the upper area of the display.
3. Select the desired MULTI OUT using the V3 knob (MULTI OUT SEL) and
press [F3] (SET) to confirm your selection.
fig.06-06

Sending Flex Bus signals to internal destinations

To send a Flex Bus's signal to another Flex Bus, the main mix or to the cue bus, set
the Flex Bus's mode to INT, for "internal destination."
Setting up Flex Bus 1 to 8 for internal use
1. Press [FLEX BUS] MASTER 1–12 in the SECTION area.
2. Press the desired Flex Bus channel's [CH EDIT].
3. Use [PAGE UP] or [PAGE DOWN] to select the [MAIN/CUE] page.
4. Set the bus mode.
Use CURSOR [UP] or [DOWN] to select the display's middle section and use [V2]
(BUS MODE) to select INT. Press [F2] (SET) to confirm the selection.
Chapter 6 Mixing Procedure 2 (Output and Monitor)
You can also access this
setting from a multi-out
channel. To do this, press
[MULTI OUT] in the
SECTION area to configure
the channel strips as multi-
out channels and press the
desired multi-out channel's
[CH EDIT] (p. 93).
To reset the MULTI OUT
selection, press [F3] (SET)
again.
Any signals sent to
MULTI OUTs 17 to 24 are
also routed to
ASSIGNABLE OUTs 1 to 8,
respectively. To route a
Flex Bus's signal to one of
the analog ASSIGNABLE
OUTs, select the
corresponding MULTI
OUT (17 to 24).
When the set of parameters
located in the middle
section of the display is
selected, you can set the
Flex Bus's output level
using the V5 knob
(LEVEL).
Since Flex Buses 9 to 12 are
always routed to their
respective FLEX BUS OUT
jacks, they cannot be routed
to internal destinations.
You can jump to this
screen by pressing the
MAIN/CUE STATUS
button while holding down
the Flex Bus channel's [CH
EDIT].
87