Connection Setting Of Processor And Console; Checking The Overall System - Roland VM-C7100 Owner's Manual

Connection Setting of Processor and Console

Up to two processors and two consoles can be connected to this system. The
following screens are for checking and setting the overall system.

Checking the overall system

1. While holding down [SHIFT], press [PROJECT].
2. Press CURSOR [UP], then [F1] (SYSTEM CONFIG).
The System Configuration Screen appears.
fig.x-x1
1
Connection status of the console itself
CONSOLE x1
PROCESSOR x1 Number of processors being used by the entire system (0 to 2)
This CONSOLE: Operation of the console (MASTER/SLAVE)
CASCADE:
VM-LINK:
2
1st UNIT... Connection status of the first processor
R-BUS BOARD
MULTI 1–8
MULTI 9–16
MULTI 17–24
VS8F-2 (A)
VS8F-2 (B)
VS8F-2 (C)
3 2nd UNIT... Connection status of the second processor
Same as the 1st UNIT.
4
1st UNIT... [F1] MASTER (SET)
Button for setting the console as the master (see next section).
The connection status of the console, processors and optional devices are displayed
on this screen. It is checked when the console is turned on. It is also re-checked when
[F1] is pressed on the above screen.
4
Chapter 2 Basic Operations and Their Settings (System/Project)
Number of consoles being used by the entire system (1 to 2)
Existence of cascade kits (VM-24C)
(Connected! (present)/Nothing (not present))
Connection status to the VM link In of the console
(Connected!/Unconnect)
VM-24E installed/not installed (checked when present)
Existence of devices connected to the first R-BUS (checked when present)
Existence of devices connected to the second R-BUS (checked when
present)
Existence of devices connected to the third R-BUS (checked when
present)
Effect expansion (A) installed/not installed (checked when present)
Effect expansion (B) installed/not installed (checked when present)
Effect expansion (C) installed/not installed (checked when present)
39