Routing Signals To Multi Outs And Assignable Out Jacks; Selecting An Output's Signal Source - Roland VM-C7100 Owner's Manual

Routing Signals to MULTI OUTs and
ASSIGNABLE OUT Jacks
You can select the signal to be sent out of the system through each MULTI OUT
connection and ASSIGNABLE OUT jack.
• MULTI OUTs 1 to 24
• ASSIGNABLE OUTs 1 to 8
• DIGITAL OUTs A and B
The following (e.g. source and level) can be set for the above outputs.

Selecting an output's signal source

One of the following can be selected as the source of the signal to be sent to each
output:
Input channels 1 to 24, Flex Buses 1 to 12, cue buses L and R, monitors buses L and
R, and main mix buses L and R.
You can set an input or Flex Bus channel's output from its CHANNEL EDIT screen
(p. 67 and p. 87), or set the output routing for multiple channels at the same time
from the MULTI OUT CHANNEL EDIT screen.
MULTI OUT CHANNEL EDIT screen
1. Press [MULTI OUT] in the SECTION area.
2. Press the desired multi-out channels [CH EDIT].
This calls up the multi-out channel's editing screen.
3. Use [PAGE UP] to select the [SOURCE] page.
fig.06-16
4. Select a source for the MULTI OUT output using the V1 knob (SOURCE
SELECT).
Straight lines show the connection of I/O channels on the screen.
Chapter 6 Mixing Procedure 2 (Output and Monitor)
To use MULTI OUTs, a
VM-24E (purchased
separately) must be
installed in the system. A
MULTI OUT is a digital
output connection made
using a Roland R-BUS
connector.
A source that's selected for
MULTI OUTs 17 to 24 will
also be sent to a
corresponding
ASSIGNABLE OUT, and,
in some cases, a DIGITAL
OUT. A signal sent to:
• MULTI OUTs 17 to 20
will also be sent to
ASSIGNABLE OUTs 1 to
4, respectively.
• MULTI OUTs 21 and 22
will also be sent to
ASSIGNABLE OUTs 5
and 6, respectively, and
to L and R of DIGITAL
OUT A
• MULTI OUTs 23 and 24
will also be sent to
ASSIGNABLE OUTs 7
and 8, respectively, and
to L and R of DIGITAL
OUT B
The output level can be set
using the V2 knob (LEVEL)
if necessary.
93