A: Display Area; Contrast Knob; Fader Utility Button; Cursor Buttons - Roland VM-C7100 Owner's Manual

Chapter 1 Introduction

A: Display area

fig.01-2
1
14 13

1...CONTRAST knob

Sets the density (brightness) of the display. Turn the knob to
optimize the display's visibility for your viewing angle.
2...DISPLAY (LCD)
Shows a level-meter screen after system is turned on.
Contents of the display change to reflect the current mixing
operation.
3...V1–V6 knobs
The V1–V6 knobs set/Adjuxt the values of the currently
selected parameters. The function of each knob depends on
the currently displayed screen.

4...LEVEL METER button

Press this button to display the level meter for each channel.

5...ANALYZER/OSC/GEN button

Calls up a screen for setting the attributes of the spectrum
analyzer and its attached oscillator and noise generator.
6...SP MODELING (MASTER FX) button
Calls up a screen for setting the master effect, the insert
effect dedicated to the stereo signal fed to the MAIN OUT
and MONITOR OUT. In addition to speaker modeling, a 10-
band parametric equalizer or 3-band dynamics processor is
also available.
7...EFFECTS 1–8 button
Calls up the main effects screen.

8...EXT SYNC button

Press this button to synchronize the Automix function to an
external time code source.
12
2
3
12
4
11 10

9...FADER UTILITY button

Calls up a screen for linking pairs of channel faders in stereo.

10...CURSOR buttons

Use these buttons to move the cursor up, down, left or right
on the screen to select a parameter—the currently selected
parameters are outlined on the display. The [LEFT] or
[RIGHT] button changes to a TIME CURSOR button when
[SHIFT] is pressed, allowing you to select the time field to
be altered using the TIME/VALUE dial.

11...PAGE buttons

Press these buttons while the page list is visible in the upper
right area of the display to change pages. Press [PAGE
DOWN] to go to the next page or [PAGE UP] to return to the
previous page.
12...F1–F6 buttons
Each of these six buttons is associated with a displayed
parameter, and is used for the adjustment of the parameter's
value. The purpose of each button depends on the parameters
presented in the currently displayed screen. Indicators of
these buttons which are assigned any functions will light.

13...EZ ROUTING button

Calls up an EZ Routing screen menu that allows you to
select or save signal routing templates. When this button is
pressed in conjunction with [SHIFT], the PATCHBAY
screen appears—this screen allows you to view and change
connections between input and output jacks and channels.

14...PROJECT button

Calls up a screen menu for saving, selecting or newly
creating a project that stores all current mixer settings. Press
this button together with [SHIFT] to call up a screen menu
of system-wide parameters (SYSTEM menu).
5 6 7
9 8