Turning The Monitor Send To Each Output Jack On Or Off; Calling Up Stored Level And Monitor Output Presets - Roland VM-C7100 Owner's Manual

Turning the monitor send to each output jack on or off

You can independently activate or de-activate the sending of monitor signals to the
following three jacks:
• MONITOR DIGITAL OUTs 1 and 2 on the console
• MONITOR LINE OUTs L and R on the console
• MONITOR OUT on the VM-7200 processor
Turning monitor signal send on or off
1. Press MONITOR/PHONES [SOURCE SELECT] while holding down
[SHIFT].
This calls up the monitor screen.
2. Use CURSOR [UP] to select the display area shown below.
fig.06-22
3. Select a jack and turn its receipt of the monitor send on or off.
Turn the V4 knob (SEND SW) to select MONITOR on the processor, DIGITAL on the
console or LINE OUT on the console. Press [F4] (SET) to turn the selected monitor
output on (highlighted) or off.

Calling up stored level and monitor output presets

You can store three sets of monitor send assignments and levels—as described in the
previous section—in a project. Pressing the panel OUTPUT PRESET [A/B/C] to turn
the output target equipment on or off restores A, B, and C to the same status as that
obtained by returning each to its original position. In this case, the state of the
DIGITAL MASTER level on the display is also stored and recalled when setting A to
C, respectively.
fig.06-23
Chapter 6 Mixing Procedure 2 (Output and Monitor)
Monitor signal is always
sent to the PHONES jack.
To avoid hearing the
signal, turn down the
[PHONES LEVEL] on the
console.
You can store three presets
containing monitor output
assignments and levels in a
project. To create the three
presets, labeled "A," "B"
and "C," select each set in
turn and set its output
assignments and levels. To
select Preset A or B, press
OUTPUT PRESET [A/B/C]
—this toggles between the
two presets. To select C,
press OUTPUT PRESET
[A/B/C] while holding
down [SHIFT].
The same signals are sent to
both MONITOR DIGITAL
OUTs 1 and 2 on the rear of
the console. You can
monitor directly from one
of these jacks by connecting
the system to two Roland
DS-90 digital monitor
speakers arranged in a
series, and setting the
speakers' rear ASSIGN
switches to LEFT and
RIGHT, respectively.
To recall Preset A or B,
press OUTPUT PRESET
[A/B/C]. Each press of [A/
B/C] toggles between
Preset A and Preset B. To
recall Preset C, press [A/B/
C] together with [SHIFT].
97