Copying Data To/From A Memory Card; Moving And Returning A Set Of Libraries In A Console To And From A Memory Card - Roland VM-C7100 Owner's Manual

Copying Data to/from a Memory Card

In this system, the project currently selected on a memory card is designed to reflect
the project on the console. This means that a memory card should always be installed
and should be considered a part of the console's internal memory that can be
removed and transported to another system.
For this purpose, one memory card is attached to the console (both VM-C7200 and
C7100) at the time of purchase.
The method for storing a project on a card is explained in detail in this chapter. The
procedure is important and it is recommended that you review it – see p. 52.
Moving and returning a set of libraries in a console to
and from a memory card
A memory card can not only store projects, but also back up libraries and EZ Routing
templates of a console's channels and effects.
Copying a set of libraries from/to a card
From the SYSTEM menu:
1. Hold [SHIFT] and press [PROJECT] (same as pressing [SYSTEM]).
2. Open the LIBRARY page on the memory card.
CURSOR
Press [DOWN], [F6] (MEMORY CARD) and [PAGE DOWN], in that
order.
fig.03-15
3. Determine what you wish to transfer to/from the card.
Select [LOAD/SAVE TARGET] – LIBRARY or TEMPLATE – on the upper section
CURSOR
using [UP] or [DOWN] and turn [F2] to [F5] on (highlighted in black) or
off. Only the items that are turned on will be saved, loaded, or exchanged.
4. Select [COMMAND] using CURSOR [DOWN].
5. Perform the function.
Select and press either [F5] (LOAD) or [F6] (SAVE). After the confirmation screen
appears, press [F5] (OK) to perform the selected function.
Chapter 3 Data Storage and Retrieval
To use the Scene function, a
memory card – which has
been formatted (p. 51) and
on which a project has been
created– must be installed.
Since auto-mix settings are
saved when a project is
stored, a card must be
prepared and a new project
created before starting
console operation.
"A set of libraries" above
includes EZ Routing
templates as well.
When a set of libraries
stored on a card is loaded
into the console, it replaces
the current user libraries in
the console. Only one set of
user libraries can be stored
on a memory card. This
means that two or more
memory cards are required
for backing-up multiple
user libraries.
"Loading" of library data
means copying it from the
card to the console,
overwriting the console's
current library. "Saving"
refers to overwriting data
from the console to the
card.
57