Stereo Multi - Roland VM-C7100 Owner's Manual

Chapter 8 Using the Internal Effects

Stereo Multi

fig.08-47
Input L
Input R
Parameter (full name)
Noise Suppressor:
Sw (Switch)
Thresh (Threshold)
Release (Release)
Compressor:
Sw (Switch)
Output Level (Output Level)
Ratio (Ratio)
Thresh (Threshold Level)
Attack (Attack Time)
Release (Release Time)
Enhancer:
Sw (Switch)
Output Level (Level)
Mix Level (Mix Level)
Sens (Sense)
Freq (Frequency)
150
Compressor/
Noise
Limiter
Suppressor
Noise
Compressor/
Suppressor
Limiter
Setting
Mutes noise in the silent mode.
On, Off
0–100
0–100
Compresses the entire output signals when the input volume exceeds a
specified value.
On, Off
-60–12 dB
1.5:1, 2:1, 4:1, 100:1
-60–0 dB
0–100
0–100
Accentuates the sound and push the sound forward.
On, Off
0–100
0–100
0–100
1.0–10.0 kHz
Enhancer 3BAND EQ
Enhancer
3BAND EQ
Function
Turns the noise suppressor on or off.
Sets the level to start muting noise.
Sets the time over which the volume will drop to 0 after the
noise starts being muted.
Turns the compressor on or off.
Sets the volume of the compressor sound.
Sets the compression ratio applied when the threshold level
is exceeded.
Sets the level at which the compressor starts taking effect.
Sets the time from when the input level exceeds the
threshold level to when the effect begins to apply.
Sets the time from when the input level drops below the
threshold level to when the effect ceases to apply.
Turns the enhancer on or off.
Sets the volume of the enhancer sound.
Sets the amount of the enhancer sound should be mixed
into the direct sound.
Sets the degree of the enhancer effect desired.
Sets the frequency at which the enhancer effect starts
working.
Output L
Output R