Graphic Eq (10-Band Graphic Equalizer) - Roland VM-C7100 Owner's Manual

*1: If Low Type (Lo Type) or High Type (Hi Type) is set to "Shelv (Shelving Type)," the setting for Lo Q or High Q
is invalid.
Frequency (p. 237), Q (p. 243), Shelving Type (p. 244), Peaking Type (p. 242), Parametric Equalizer (p. 241)

Graphic EQ (10-Band Graphic Equalizer)

This Equalizer sets the boost/cut amount by each segment of the frequency divided into ten bands. In performing
PA at a live, this feature is useful to prevent howling by cutting the site-specific resonance frequency.
fig.08-57
Input A
Input B
Preventing howling
While performing PA at a live, follow the steps below to prevent howling. First, identify the site-specific
resonance frequency to cut its gain.
Controlling Channels A and B separately
Setting Link On enables simultaneous control on the 10-Band Parametric Equalizer via Channel B according to
the settings on the Channel A side.
To control Channels A and B separately, turn Link Off.
Parameter (full name)
Link:
Link (Link Switch)
10 BAND EQ ch A/10 BAND EQ ch B (10-Band Graphic Equalizer): Simulates a 10-band graphic equalizer.
Sw (Switch)
INPUT LEVEL (Input Level)
OUT LEVEL (Output Level)
31.2 - 16 k (Gain)
• To switch the band, turn the V3 (BAND) knob, or press [F3] (BAND-) or [F4] (BAND+).
• When returning the input level, the output level, and the gain of each band to 0, press [F2] (ALL RST).
• When returning the gain of the band selected currently to 0, press [F5] (RESET).
Graphic Equalizer (p. 237)
Output A
10BAND EQ A
Link
10BAND EQ B
Output B
Setting
Makes Channel B follow the settings for Channel A.
On, Off
On, Off
-60– +15 dB
-60– +15 dB
-15– +15 dB
Chapter 8 Using the Internal Effects
Function
Specifies if Channel B follows or does not follow the
settings for Channel A.
Turns the parametric equalizer on or off.
Sets the overall volume before passing through the
equalizer.
Sets the overall volume after passing through the equalizer.
Sets the boost/cut amount at the respective frequencies.
157