Roland VM-C7100 Owner's Manual page 227

Chapter 12 Using with MIDI Devices
[SHIFT] + [PROJECT]
fig.12-02
• [EXT SYNC]:
• SYNC MASTER:
• SYNC OFFSET:
• FRAME TYPE:
• MMC CONTROL:
• MMC MASTER:
To make an external MIDI device synchronize with the
console (when the console is used as the master)
To make the external MIDI device synchronize with MTC or MIDI clock transmitted
from the console, connect them as shown below, and set the required parameters.
fig.12-03
226
CURSOR [DOWN] [F3] (SYNC CLOCK)
ON
EXT, MTC
Provides the time on both the console and other
devices with an offset when the console is being
synchronized with video or similar equipment.
Sets the frame rate for the device to be connected.
ON (Only when the external MIDI device controls
synchronization start and stop.)
MIDI (Only when the external MIDI device
controls synchronization start and stop.)
The processor also has a
MIDI OUT/THRU/
METER connector which is
used in the same way as
that on the console. When
the external MIDI device
has been connected to the
processor, set MIDI THRU
PROCESSOR to "OUT" on
the SYSTEM MIDI screen.
When the MB-24 (Level
Meter Bridge) is used,
connect between the MIDI
OUT/THRU connector of
the MB-24 and the MIDI IN
connector of the external
MIDI device.