Preparing A Memory Card For Project Storage - Roland VM-C7100 Owner's Manual

Preparing a memory card for project storage

Before using a new memory card or one that has been used for another purpose, be
sure to format it.
Formatting a memory card
1. Hold [SHIFT] and press [PROJECT] – this is the same as pressing [SYSTEM].
After the menu appears, press
fig.03-08
2. Press [F6] (MEMORY CARD) and [F2] (FORMAT), in that order.
fig.03-09
3. Press [F5] (OK) by following the displayed directions.
4. After the confirmation message appears, press [F5] again.
Formatting starts. After it is completed, press [F6] (EXIT).
In order to store a project on a formatted memory card, a new project must be created
on the card before starting the storage operation.
Chapter 3 Data Storage and Retrieval
CURSOR
[DOWN] to display the following screen.
After formatting, all data
on the card is erased.
If you press [F6]
(MEMORY CARD), [F3]
starts functioning as the
"SCAN" button. You can
update a project list on the
screen by inserting another
card and pressing this
button when the screen is
open.
The numbers (00, 01, 02,
etc.) listed after formatting
show you the number of
projects the card can hold.
51